Owner`s manual

SEEK, SCAN or TUNE button.
2. Select the desired station and keep push-
ing any of the desired station memory
buttons (1 to 6) until a beep sound is
heard. (For example, in the diagram ch2 is
to be memorized. The radio mutes when
the select button is pushed.)
3. The indicator ch2 will then come on and
the sound will resume. Memorizing is now
complete.
4. Other buttons can be set in the same
manner.
If the battery cable is disconnected, or if the
fuse blows, the radio memory will be can-
celled. In that case, reset the desired stations.
(Automatic preset) button :
To select the preset FM, AM or PTY station,
push the AUTOP button for less than 1.5
seconds.
To preset the FM, AM or PTY station, push
the AUTOP button for more than 1.5 seconds.
(Program type) button :
When PTY button is pressed during FM mode,
the PTY name of the current tuned station is
displayed. During this time if the PTY data
code is zero, or the data is unreadable; the
display will show NONE.
1. PTY selection mode
PTY name selection can be done by the
up/down TUNE button
or in
the PTY selection mode.
After selecting a PTY name, push the
TUNE button
or within 10
seconds. Tuning to the PTY station will
start. If you do not push the TUNE button
within the 10 second period, the PTY
mode will be canceled.
It is possible to shift the PTY name by one
step, with one push of the up/down tuning
button
or .
PTY name selection can also be achieved by
pressing the preset buttons.
Initial PTY names are stored in the preset
buttons; but these can be changed by pressing
the preset buttons for more than 1.5 seconds
when the desired PTY name is in the display.
HEATER, AIR CONDITIONER AND AUDIO SYSTEMS
4-18
Z 01.9.13/JR50-D X