Owner`s manual

SCAN or TUNE buttons.
2. Select the desired station and keep push-
ing any of the desired station memory
buttons (1 to 6) until a beep sound is
heard. (The radio mutes when the select
button is pushed.)
3. The channel indicator will come on and the
sound will resume. Memorizing is now
complete.
4. Other station select buttons can be set in
the same manner.
If the battery cable is disconnected, or if the
radio fuse opens, the radio memory is can-
celled. In that case, reset the desired stations.
Program type :
When PTY button is pressed during FM mode,
the PTY name of the current tuned station is
displayed. During this time if the PTY data
code is zero, or the data is unreadable; the
display will show NONE.
1. PTY selection mode
PTY name selection can be done by the
up/down TUNE button
or in
the PTY selection mode.
It is possible to shift the PTY name by one
step, with one push of the up/down tuning
button
or .
PTY name selection can also be achieved by
pressing the preset buttons.
Initial PTY names are stored in the preset
buttons; but these can be changed by pressing
the preset buttons for more than 1.5 seconds
when the desired PTY name is in the display.
2. PTY SEEK tuning
After selecting a PTY name, push the
TUNE button
or within 10
seconds. Tuning to the PTY station will
start. If you do not push the TUNE button
within the 10 second period, the PTY
mode will be canceled.
HEATER, AIR CONDITIONER AND AUDIO SYSTEMS
4-12
Z 01.9.13/JR50-D X