Owner`s manual

button repeatedly until the radio or cassette
tape display appears.
Radio/Cassette tape priority
mode
In this mode, the radio station illuminates in
the display during radio operation. During
cassette tape operation, TAPE illuminates in
the display.
FM-AM radio operation
FM-AM band select :
Pushing the FM-AM band select button will
change the band as follows:
AM → AM (preset station) → FM1 → FM2
→ FM (preset station) → AM
When FM/AM band select button is pushed
while the ignition switch is in the ACC or ON,
the radio will come on at the station last
played.
The last station played will also come on when
the power knob is turned to ON.
If a compact disc or tape is playing when the
FM/AM band select button is turned to ON,
the compact disc or tape will automatically be
turned off and the last radio station played will
come on.
The FM stereo indicator ST illuminates during
FM stereo reception. When the stereo broad-
cast signal is weak, the radio automatically
changes from stereo to monaural reception.
TUNE (Tuning) :
WARNING
The radio should not be tuned while
driving so full attention may be given
to vehicle operation.
Use these buttons for manual tuning. To move
quickly through the channels, hold either of
the TUNE buttons down for more than 0.5
seconds.
SCAN tuning :
Push the SCAN tuning button and SCAN will
illuminate in the display window. SCAN tun-
ing begins from high to low or low to high
frequencies and stops at each broadcasting
station for 5 seconds. Pushing the button
again during this 5 second period stops SCAN
tuning and the radio remains tuned to that
station.
If any of the SEEK/SCAN tuning buttons are
not pushed within 5 seconds, SCAN tuning
moves to the next station.
Station memory (and preset) opera-
tions :
Twelve stations can be set for the FM band
(six for FM1, six for FM2) and six stations can
be set for the AM band.
1. Tune to the desired station using the
HEATER, AIR CONDITIONER AND AUDIO SYSTEMS
4-11
Z 01.9.13/JR50-D X