Owner`s manual

hand-held transmitter 2 to 5 inches (50 to
127 mm) away from the HomeLinkT sur-
face.
3. Press and hold the hand-held transmitter
button.
4. The HomeLinkT indicator light will flash,
first slowly and then rapidly. When the
indicator light begins to flash rapidly,
release both buttons.
The HomeLinkT Universal Transceiver button
has now been reprogrammed. The new device
can be activated by pushing the HomeLinkT
button that was just programmed. This pro-
cedure will not affect any other programmed
HomeLinkT buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change
the codes of any non-rolling code device that
has been programmed into HomeLinkT. Con-
sult the Owner’s Manual of each device or call
the manufacturer or dealer of those devices for
additional information.
Whenyourvehicleisrecovered,youwill
need to reprogram the HomeLinkT Uni-
versal Transceiver with your new trans-
mitter information.
FCC Notice:
ThisdevicecomplieswithFCCrulespart
15. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference and (2) This
devicemustacceptanyinterferencethat
may be received, including interference
that may cause undesired operation.
The transmitter has been tested and
complies with FCC and DOC/MDC rules.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s au-
thority to operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
INSTRUMENTS AND CONTROLS
2-51
Z 02.2.7/JR50-D X