Owner`s manual

To program the remaining two buttons, follow
steps 2 through 4.
If, after repeated attempts, you do not suc-
cessfully program the HomeLinkT Universal
Transceiver to learn the signal of the hand-
held transmitter, refer to “Rolling Code Pro-
gramming” later in this section.
PROGRAMMING HomeLink T
FOR CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your hand-held
transmitter to HomeLinkT, continue to press
and hold the HomeLinkT button (note steps 2
through 4 under “Programming HomeLinkT”)
while you press and re-press (“cycle”) your
hand-held transmitter every 2 seconds until
the indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener,
etc., it is advised to unplug the device
during the “cycling” process to prevent
possible damage to the garage door
opener components.
OPERATING THE HomeLink T
UNIVERSAL TRANSCEIVER
The HomeLinkT Universal Transceiver (once
programmed) may now be used to activate the
garage door, etc. To operate, simply press the
appropriate programmed HomeLinkT Univer-
sal Transceiver button. The red indicator light
will illuminate while the signal is being
transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLinkT does not quickly learn the
hand-held transmitter information:
O replace the hand-held transmitter batteries
with new batteries.
O position the hand-held transmitter with its
battery area facing away from the
HomeLinkT surface.
O press and hold both the HomeLinkT and
hand-held transmitter buttons without in-
terruption.
O position the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLinkT surface. Hold the transmitter
in that position for up to 15 seconds. If
HomeLinkT is not programmed within that
time, try holding the transmitter in another
position - keeping the indicator light in
view at all times.
If you continue to have programming difficul-
ties, please contact the INFINITI Consumer
Affairs Department. The phone numbers are
located in the Foreword of this Owner’s
Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared, however
INSTRUMENTS AND CONTROLS
2-49
Z 02.2.7/JR50-D X