User Guide

Page 12UG10637-1.0 - Inca 500 User Guide V1.0

5.2.2 Wireless (WiFi) Network Connection

To connect an Inca 500 ampliﬁer to a TCP/IP network using a wireless connection (WiFi)

follow the steps below.

1. With the Inca 500 ampliﬁer connected to mains power, wait for the front panel WiFi

indicator to illuminate green.

2. Use a mobile, laptop or desktop device to search for available WiFi networks. Connect

to, Inca 500 (product serial number)’ using the password, ‘password’. The ampliﬁer serial

number can be found on its rear panel.

3. Open a computer or mobile device web browser and enter the IP address: 192.168.4.1.

The Inca 500 Web App interface will open to enable ampliﬁer conﬁguration as required.

4. Select the Web App Settings Tab followed by WiFi > WiFi Mode > Client to conﬁgure the

ampliﬁer to connect to the required WiFI network. The WiFi network name and password

will be required.

It is strongly recommended that the Inca 500 ampliﬁer Access Point WiFi password is

changed following initial wireless connection.

5 Conﬁgurations