User Guide

Page 10UG10637-1.0 - Inca 500 User Guide V1.0
4 Installation
Figure 4.5: Inca 500 wall and under-desk mount.
4.2 Free-standing
If not installed in an equipment
rack, Inca 500 amplifiers can be
placed free-standing on a flat
surface. Adhesive rubber feet are
supplied for this purpose.
Inca 500 amplifiers can also be
attached to the underside of desks
or wall mounted using connecting
plate hardware. The adhesive
rubber feet should also be used in
these circumstances to minimise
the possibility of vibration between
the amplifier and mounting
surface. Wall and desk mounting is
illustrated in figure 4.4 and 4.5.
It is important in any free standing
installation that airflow through
the amplifier’s side
panel mounted
fans and rear panel
ventilation apertures is
not compromised by
adjacent items. At least
80mm of free space
behind the amplifier
and 25mm along at
least one side should
be retained at all times.
Figure 4.4: Inca 500 with desk/wall Mounting Plate and
adhesive feet. 2 positions and 4 positions.
Mounting Plate +
2 x M3 x 6 countersunk
Adhesive Foot
4 positions