Service manual

HEC-Series Service Manual
INSTALLING YOUR TUBE-ICE MACHINE
10/21/01
3-2
FIGURE 3-1
Forklift-&-Blocks Method
You need: + forklift truck with adequate load and height capacities
+ (8) 2X4 wood blocks 8 in. long
+ (2) wooden 2X4’s measuring 3-ft. long
+ pry bar
Step 1. Position Tube-Ice
®
machine on forks.
! CAUTION !
The Tube-Ice
®
machine may be somewhat top heavy on the rear.
! CAUTION !
Step 2. Stack wood blocks in each corner of the drip pan on top of the ice storage
bin.
Step 3. Lift and set Tube-Ice
®
machine on wood blocks.
Step 4. Remove forklift.
Step 5. Stack 3-ft. long 2X4’s beside drip pan, overlapping front and back of bin.
Step 6. Using a pry bar with fulcrum on 2X4’s, raise side of machine enough to
remove the TOP wood blocks.
! CAUTION !
Do not remove top AND bottom blocks at the same time.
! CAUTION !
Step 7. Repeat steps 5 and 6 on other side.
Step 8. With machine sitting on one (1) block under each corner, repeat steps 5, 6,
and 7 remove remaining blocks. Drip pan flanges may bend slightly.
Step 9. Straighten bent drip pan flanges.
Step 10. Check alignment of ice chute to bin opening.