Product Manual

F6 Blower Kit Instruction Sheet
ASSEMBLY INSTRUCTIONS
Step 1.
Align ceramic gasket with rear defl ector heat shield and blower assembly so
it does not block the fan opening.
Step 2.
Fix the assembly to the back of the stove with the four machine screws provided.
Step 3.
Once the stove is positioned,
plug the power cord into a
grounded 120V outlet.
Blower Maintenance
The blower is maintenance free other than periodic cleaning. Lightly vacuum motor and air inlet to keep
free of dust and dirt.
Wiring Diagram
THE BLOWER ASSEMBLY MUST BE DISCONNECTED FROM THE SOURCE OF ELECTRICAL SUPPLY
BEFORE ATTEMPTING THE INSTALLATION.
THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY WITH A STOVE THAT IS MARKED TO
INDICATE SUCH USE.
DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS HOT SURFACES!
DANGER: SHOCK HAZARD.
DISCONNECT POWER SOURCE
BEFORE INSTALLATION AND
WHENEVER SERVICING BLOWER
ASSEMBLY.
NOTICE: DO NOT ALLOW POWER
CORD TO TOUCH HOT SURFACES!
KEEP POWER CORD AT LEAST 12"
FROM STOVE OR PIPE SURFACES.
CAUTION: MOVING PARTS CAN
CAUSE INJURY. DO NOT OPERATE
WITH COVER REMOVED.
NOTICE: ANY REPLACEMENT
WIRING MUST HAVE EQUIVALENT
INSULATION AND TEMPERATURE
RATING (105°C).