Programming Instruction

 Some of the key fobs could be programmed by following the step-by-step instruction. But
some must be cut and programmed by qualified locksmith or dealer.
 If you have no idea about the compatibility between your vehicle and key replacement, you
could search for instruction on http://www.programyourremote.com/ or search on YouTube.
 If it still does not work after self-programmed, please turn to local locksmith or dealer for
technical help.
 Avoid severe impact. The key fob is designed to withstand impact under normal use even if it
is made of good quality material. It is not recommended to subject it to severe impact or
rough usage.
--- satisfaction using experience ---
All of our key fobs contains electronics components (some uncut key contained), you have
no need to prepare electronics or batteries. If there is any problem without the key fob, just contact
VOFONO and send a message to us by Amazon.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4) Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. The device has
been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.