User guide

Door Opener 61
XTS-IP / XTSc-IP Station User Guide December 2005
Door Opener
When the system’s administrative programming is set to use the relay
contact as a door opener, the relay is activated by either dialing flexible
feature code 665 or by pressing a preprogrammed flexible button that
has code 665 assigned. When the relay is open, the flexible button LED
lights steady; when the relay is closed, the LED is off.
Executive Override
Executive Override allows stations designated as “Executive” the ability
to override and “barge in” on other keysets engaged in CO Line
conversations. A change in volume may occur on the CO Line or
intercom call after the barge-in occurs.
If you call a busy station:
1. Press the preprogrammed EXECUTIVE OVERRIDE button (625). The
Executive station is bridged onto the CO line conversation in
progress at the called station. An optional warning tone is
presented to all parties prior to cut-thru.
 The conversation in progress is received on the Supervisor’s
handset and the Executive’s MUTE button LED is lit to indicate
that the Executive’s transmit is muted.
 To participate in the conversation in a true conference mode,
the Executive can press the MUTE button to remove the mute
condition.
2. Replace the Executive station handset to terminate the override.
Use of this feature when the executive override
warning tone is disabled may be a violation of Federal,
State or Local Laws, and an invasion of privacy. Check
applicable laws in your area before using this feature.