User guide

XTS-IP / XTSc-IP Station User Guide December 2005
78 Keyset Mode
Keyset Mode
This feature allows you to determine the mode and baud rate of the
optional CTI Module connected to your phone. This setting is stored in
back-up memory in the case of a power outage or system reset. When
phone is set to AT command mode, these AT commands are supported:
At an idle station:
1. Dial the Keyset Mode code [648] on the dial pad,
-or-
Press the preprogrammed KEYSET MODE button, the display shows:
2. Press [
] to scroll through the keyset modes.
Command
Mode
Description
Inactive No CTI information is sent/received by the telephone.
ATD Modem Dialing Command -- The telephone will recognize
the ATD and accept digits after the command.
ATH or ATHX
(X= 0 or 1)
Modem On-Hook / Off-Hook Command -- ATH or ATH0 will
force the telephone to go to the on-hook state from its
current state. ATH1 will force the telephone to go to the off-
hook state from it’s current state.
CKTU Command used with Wanderer (a cordless key telephone unit).
Baud rate is not used in this mode; no change is necessary.
PC Phone CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI Service Provider Interface -- Command used with 1st Party
Call Control TAPI applications such as Discovery Link
TAPI For 3rd Party Call Control TAPI applications such as Discovery
Net Phone.
CKTU & TAPI For simultaneous use of CKTU and 3rd Party Call Control TAPI
INACTIVE 2400
MODE= SAVE=HOLD BAUD=#