Specifications

CO/PBX Connections 3-39
Chapter 3 - System Installation
XTS-IP - Installation Manual December 2005
Note: LED 09 is closest to the Ethernet port.
Figure 3-23: VoIP Card - No VoIP Modules Installed
Figure 3-24: Connection Side of VoIP Module (Close-up)
Table 3-16: VoIP Card LED Indications
LED Indication ON OFF
09 LAN Speed 100 Mbps 10 Mbps
10 Rx Status Active Idle
11 Tx Status Active Idle
12 Link Status Valid Link No Link
13 Collision Status Collision No Collision
14 Half/Full Duplex Mode Half Duplex Full Duplex
Dip switch 1 is used to control the Trace Mode (ON position = Brief Trace Mode
and OFF position = Detailed Trace Mode).
Dip switches 2-8 are reserved for future use.
VoIP FirmwareDip Switches