Specifications

Flash ROM Software Update 4-29
Chapter 4 - Maintenance and Troubleshooting
XTS-IP - Installation Manual December 2005
The following command options and system prompt will display:
5. Type s and press <Enter> to enable bank switching.
The following message will display:
6. To use the newly loaded software, place switch 8 to the on position (to default KSU
database). Power the XTS-IP system Off or On, whichever applies. When the system is up,
place switch 8 to the off position and upload the database (refer to “Database UPload/
Download Routine” in Appendix F of the Programming and Operations Manual). After the
upload, cycle KSU power.
The “s” command is used as a toggle. Therefore, if bank switching is enabled,
type s, and then press <Enter> to disable.
COMMAND DESCRIPTION
____________________
b show baud rate
s bank switching
u upload software using zmodem
x Exit
? or h Help, Guide
maint>swupdown>
Bank switching is enabled...
Please, make a reset to initiate switching banks...