Specifications

Maintenance Access 4-19
Chapter 4 - Maintenance and Troubleshooting
XTS-IP - Installation Manual December 2005
Event Trace Buffer
The Event Trace Buffer is used to store and dump event traces (up to 30) that occur just prior
to an XTS-IP System soft or hard restart. These can be reviewed by authorized personnel to aid
in system troubleshooting. The basic format for each command is shown in the following table:
Table 4-16: Event Trace Buffer Commands
Command Function
t<space><Enter> Displays the current status of the Event trace buffer.
t<space>0<Enter> Turns the Trace buffer OFF.
t<space>1<Enter> Turns the Trace buffer ON to record events prior to a soft
system reset.
t<space>2<Enter> Turns the Trace buffer ON to record events prior to a hard
system restart.
t<space>3<Enter> Turns the Trace buffer ON to record events prior to either a
soft reset or a hard system restart.
d<space>E<Enter> Dumps Trace Events stored from last system reset (soft or
hard).
d<space>b<Enter> Permits maintenance personnel to determine the busy
status of all the busy keysets and CO Lines in the system,
including the T1 lines.
r<space>SXXX<Enter> Permits a specific station to be reset.
r<space>CXX<Enter> Permits a specific CO Line to be reset.
Press <Ctrl + C> to abort the Data Dump and return to the maint> prompt.