Specifications

Flash-Based Voice Mail System 3-61
Chapter 3 - System Installation
XTS-IP - Installation Manual December 2005
Flash-Based Voice Mail System
This section describes how to install the Flash-Based Voice Mail board.
Installing the Voice Mail Interface Board
The Flash-Based Voice Mail Card consists of a printed circuit board. It can be installed into
slots 1-7 of Cabinet 0, and into slots 0-7 of Cabinets 1 and 2.
Figure 3-33: Flash-Based Voice Mail Card
Installing the Memory Expansion Module
Refer to Figure 3-33: Flash-Based Voice Mail Card to locate the proper placement for the
optional memory expansion module.
You must power down the system before installing the memory expansion module.
Memory Expansion
Module Location
RS-232 Connector for
Programming, 9600, N-8-1