Specifications

STARPLUS@ 616 FLEX
KEY TELEPHONE SYSTEM
620.2
CO LINE SETTINGS
PROGRAMMlNG STEPS
If you are in the programming mode, continue using
program codes. If you are starting to program here,
enter the program mode first.
if any CO line features are to be changed, dial an
asterisk (*) and [I 21 on the dial pad.
If you have a display phone, you will see the follow-
1. Press the CO line button of the line
programmed.
to be
2. Toggle the program buttons ON or OFF, de-
pending on the CO Line features desired.
l If LED is ON, feature is enabled
0 If LED is OFF, feature is disabled
3. When all changes have been made, press the
HOLD button. The next CO Line button will light
for programming.
‘/Inn/1
Iiiii_.i
FLEXIBLE BUlTON FIELD
SUB-FIELD BUTTONS
DESCRIPTION
The CO Line/PBX features are described as follows:
Line Type (COIPBX)
Each individual outside line can be programmed to
be either a CO line or a PBX line. This should also
be used for identifying Centrex lines.
When marked PBX, a one or two digit dialing code
may be entered after which toll restriction, Sec.
630.5, is applied to the next dialed digit.
Default: All lines are CO Lines (LED ON)
Related Programming:
When programming line type, Refer to CO line group
programming, Sec. 620.1; Flexible button program-
ming, Sec. 610.5; CO line ringing, Sec. 620.3; Flash
timer, Sec. 620.4; and recall timers, Sec. 630.2.
When marked PBX, a one or two-digit dial code may
be entered after which toll restriction, Sec. 630.5, is
applied to the next dialed digit.
Signaling (DTMF/Pulse)
Each individual line can also be programmed as
either DTMF (tone) or dial pulse.
Default: All lines are set for DTMF (LED ON)
Related Programming:
When a line is assigned as dial pulse, you can
program the break/make ratio and dial speed to
match the serving central office, Sec. 620.6. Refer
also to the ring detect timer, Sec. 620.5.
Toll Restriction Override
An outside line may be marked for Toll Override
which allows even restricted stations to dial on this
line.
This feature allows you to give a station a restrictive
COS and also give them a line they can make long
distance calls over. 7%is feature also affects system
speed dial by allowing certain speed numbers fo be
programmed on a specific line.
Default: By default, no lines are marked for toll
override (LED OFF).
Related Programming:
To assign a Class of Service (COS) to stations, Refer
to Sec. 610.1.
620-2 ISSUE 1, JANUARY 1991