Specifications

sTARPLUS@ 616 FLEX
KEY TELEPHONE SYSTEM
610.5 FLEXIBLE BUTTONS
PROGRAMMING STEPS
If you are in the programming mode, continue using
program codes. If you are starting to program here,
enter the program mode first.
To program your flexible buttons, dial an asterisk (*)
and [OS] on the dial pad.
If you have a display phone, you will see the follow-
ing:
1. Dial the two-digit station number (1 O-25) on the
dial pad. -
2. Press any button which you want to
See the following program buttons:
FLEXIBLE BUlTON FIELD
change.
SUB-FIELD ElUlTONS
DESCRIPTION
Each flexible button may be given a general assign-
ment such as multi function button, station button,
CO line button, loop key or pool key.
Multi function buttons are programmed by each in-
dividual userto be a DSS (station) button, speed dial
button, page button or mute button.
A multi function button can be programmed in the
system data base as a sfafion button. After entering
a “1: enter the station number desired, and press
HOLD. The station user can erase this program-
ming.
When programming a button as a CO line button, the
line number must also be specified.
When programming a button as a CO line button,
refer to CO line tinging (Sec. 620.3. By default,
Station 10 will ring on a line. However, if Station 10
is not given button access to a line, another station
must be programmed to ring on that line.
When programming a pool button, the line group
number must also be entered.
Default: By default, flexible buttons are assigned as
follows:
BASIC Telephone:
Buttons 1-6 = CO lines 1-6
ENHANCED/EXECUTIVE Telephone:
Buttons l-l 6 = Stations 1 O-25;
Buttons 17-22 = CO lines l-6
610-6
ISSUE
1.
JANUARY
1991