Specifications

STARPLUS@ 616 FLEX
KEY TELEPHONE SYSTEM
SECTION 610
STATION CONFIGURATION
610.1
STATION CLASS OF SERVICE
PROGRAMMING STEPS
Make sure you have entered the programming mode
(Sec. 600.4).
If you wish to change the Class of Service of a
station, dial an (*) asterisk & [01] on the dial pad.
If you have a display phone, you will see the follow-
ing:
1. Press the button of the station to be assigned a
class of service.
2. Then press appropriate button for the class of
service being assigned to that station - see
below. By default all stations are assigned
Class of Service 1 (unrestricted).
3. When all changes have been made, press the
HOLD button. The next station button will light
for programming.
DESCRIPTION
Each station must be assigned a class of service
which determines the type of calls a station may
make. There are 2 Toll Restriction tables labeled A
and B in which you may enter long distance numbers
to be allowed or denied (Refer to Section 630.13).
- Class 1 = Unrestricted
- Class 2 = Follows entries in Allow & Deny
Table A
- Class 3 = Follows entries in Allow & Deny
Table B
- Class 4 = Allows 7 digits maximum, denies
“0” or “1” as the first digit dialed
- Class 5 = Intercom & paging only
- Class 6 = Receive only/Phone Box (no dial-
ing)
Tables A & B must be programmed in order for
COS2 and COS3 to function.
Default: All Stations are assigned COSl (LED ON)
Related Programming:
When a CO line is marked PBX, COS restrictions
apply to the station only if one of 4 PBX Codes are
dialed first, Refer to Sec. 630.5.
Stations must be programmed to receive phone
box/alarm signaling, Refer to Sec. 610.2; and must
also be programmed with the corresponding station
button of the phone box, Refer to Set 610.5
SUB-FIELD BUTTONS