Specifications
BARPLUS@
616 FLEX
KEY TELEPHONE SYSTEM
300.54 AllENDANT ACTIVATION OF BACK-
GROUND MUSIC AT A PHONE BOX
The Attendant may control (turn ON and OFF) back-
ground music at a phone box station.
To control background music at a specific phone
box:
1. Dial [42] on the dial pad.
2. Then dial the two-digit station number (10-25)
of the desired phone box.
3. Dial either:
- [0] to turn BGM off.
OR
- [I] to turn BGM on.
300.55 AlTENDANT OVERRIDE (Camp-on)
If the Attendant calls a station that is either Busy or
in DND and wishes to alert them of a call:
1. Press the MSG/CP.ON button twice. Called
station will receive 2 bursts of ringing.
2. Wait for their response.
300.56 FLEXIBLE STATION NUMBERS
This feature allows the Attendant to SWAP an indi-
vidual stations’ programmed data including speed
dial and intercom number with another active station
in the system.
This feature requires the user to know the “PORT”
of the station requesting to be changed (The LCD
will provide this information).
Remember: Ports NEVER change, but station inter-
com numbers DO.
Note: The stations affected must be idle before
changes made in station numbers will take effect.
At Attendant station:
1. Enter [**STAT] on the dial pad. Confirmation
tone is heard.
2. Enter [*04] on the dial pad. (LCD shown will be
displayed)
Press the PORT? button of the station whose
intercom number is to be changed (LED will
flash).
‘Port = the sequence in which the telephones
are connected to the main switching unit. The
LCD display will indicate the intercom number
associated to each port. To view stations, press
a PORT button, then its assigned intercom
button.
Port Button Mapping
4. Press the station button of the intercom number
it is to be changed to. Confirmation tone will be
heard. LCD will now update to show new as-
sianment.
ST,
Station Button Mapping
5. Make sure ALL ports are assigned an intercom
number. (ie: a minimum of 2 ports must be
changed.)
Example: Assign Port 01 to Intercom number
12, then assign Port 03 to Intercom number 10
6. Repeat Steps 3 & 4 to assign additional sta-
tions.
7. Press the HOLD button after all changes have
been made. Confirmation tone will be heard.
8. Press ON/OFF button OFF to end sequence.
I
NOTE
The Attendant Station may NOT enter the
Flexible Station Number programming
[*‘STAT/ if the Programming Station (PORT
01) is actively in a programming section and
vice versa.
7