Specifications
STARPLUS @
616
FLEX
KEY TELEPHONE SYSTEM
300.43 CALL FORWARDING (Station)
300.46 USING ACCOUNT CODES
If you have been given the ability to forward your
You are on an existing call.
Calk:
1. Press FWD/DND button.
1. Lift handset or press ON/OFF button.
2. Dial account code up to 8 digits. (The other
2. Press FWDIDND button.
party will not hear the digits being dialed.)
Then:
3. Press station button.
OR
4. Dial intercom number, within 5 seconds, where
your calls are to be forwarded. (FWDIDND but-
ton will flash and dial tone returns)
5. Hang up.
300.44 TO REMOVE CALL FORWARDING
1. Lift handset or press ON/OFF button.
2. Press FWDIDND button.
Then:
3. Press your own station button
OR
4. Dial your own intercom number.(FWD/DND
button LED extinguishes)
5. Hang up.
300.46
ALARM
If you hear alarm signals on your telephone.
To reset the alarm condition:
1. Dial [9] on the dial pad.
OR
2. Press programmed flex button.
I
NOTE
If the account code is less than 8 digits, dial
‘*’ to end account code entry. Account
ze must be entered during the call.
300.47 FLEXIBLE BUTTON PROGRAMMING
Allows a user to utilize a feature by programming it
onto a flex button. Buttons MUST be designated as
multi-function by the system administrator and may
be programmed by the user. The feature can then
be activated without lifting the handset by pressing
the ON/OFF button.
1. Press asterisk (*) once.
2. Press button to be programmed.
3. Dial desired feature access code from the fea-
ture code table below.
4. Press the HOLD button to complete the proc-
ess.
NOTE: The speed bin must be programmed with a
number before a flexible button can be assigned as
a speed button.
FLEXIBLE BUTTON PROGRAMMING CODES
Feature..
Feature
............................
..........................
QJ&
?
DSS/BLF ......................... 1 O-25
Headset Option ............... 41
Music.. ............................. 8
Paging:
Alarm Reset
Internal All Call.. ........... 70
....................
9
Speed Bin.. SPD plus 2 digit number
Internal Zone
1 ............. 71
......................
- Station speed bin..
Zone 2..
...........
.....
00-09
Internal
72
- System speed bins.. 1 O-49
External Zone .............. 73
..
- Station speed bins ..... 90-99
System All Call ............ 74
Mute
40
Meet Me Page ................. 75
................................
Last Number Redial......... SPD+#
NOTE: The speed bin must be programmed with a number before a flexible button
can be assigned as a speed button.
300-S
MARCH.
1994
ISSUE 1. JANUARY 1991