Specifications

630.14 STATION SPEED DIAL
Each telephone has 20 unique speed dial numbers.
These numbers are entered and stored by the user
and can be recalled by the user at any time.
The asterisk (‘) is used to program a pulse-
to-tone switchover. Subsequent ‘*I dialed will
cause the DTMF digit ‘*’ to be dialed.
The TRANS/QUE button is used to program
a pause
The FLASH button is used to program a flash
command.
To program a “No Display”, press the CONF
button.
The asterisk (‘) and pound (#) can be pro-
grammed as digits.
To program a station speed number:
1. Press SPD button.
2. Press the asterisk (‘).
3. Enter speed bin number (00-09,90-99).
4. Press outside line button if desired.
5. Enter telephone number.
6. Press HOLD button to enter the data.
To program additional numbers, repeat program-
ming from step 2.
630.65 PULSE-TO-TON5 SWITCHOVER
The user can command the system to change the
signaling on a CO line from dial pulse to DTMF tone
thereby allowing the use of common carriers behind
a dial pulse line.
This can be done either manually or programmed
into a speed dial number.
To manually command a switchover, the user, while
connected to an outside line, dials an asterisk (‘).
The switchover occurs and the succeeding digits are
sent DTMF.
When using speed dial numbers, the asterisk (*) is
stored and sent with the number. The system will
automatically insert a pause and then switch over to
DTMF sending for the remaining digits.
630.16 FLASH WITH SPEED DIAL
During the dialing of a station or system speed
number, a flash can be programmed into the num-
ber. A pause will automatically be inserted after the
flash before the remaining digits are sent.
When programming a speed number, pressing the
FLASH button will program a flash command. This
is counted as a digit. The flash length and pause
following are determined by programming.
630.17 NUMBERING PLAN
1 O-25
40
41
42
5#
55
6
70
71
72
73
74
75
8
9
0
l
#
00-99
1 o-49
90-99
Intercom Numbers,
Mute (Flex button)
Headset/Handset mode
Attn Phone Box BGM
Enable/Disable
Calling Station Tone Mode Option
Universal Night Answer
Call Pickup
Internal All Call Page
Internal Zone 1 Page
Internal Zone 2 Page
External Zone Page
All Call Page
Meet Me Page Answer
Music
Alarm Reset
Attendant
Pulse-To-Tone Switchover
(CO line or Speed Dial
Last Number Redial
Station Speed Dial
(Preceded by SPD button)
System Speed Dial
(Preceded by SPD button)
Station Speed Dial
(Preceded by SPD button)
NOTE: The speed bin must be programmed with a
number before a flexible button can be assigned as
a speed button.
630.18 NIGHT SERVICE
The 616 FLEX Key Telephone System is placed into
Night Service by the Attendant pressing the DND
button at her key telephone.
To remove Night Service, the Attendant reverses the
procedure. When the system is in Night Service,
stations marked to ring at night will function accord-
ing to access and ring assignments programmed in
Sec. 620.2.
636-26
ISSUE 1, JANUARY 1991