Specifications

Diagnostic/Maintenance 4-9
Chapter 4 - Maintenance and Troubleshooting
log gw clear clears previous gateway logs
log gw view displays specific gateway logs
log mfim clear clears previous MFIM logs
log mfim view displays the system reset logs held in the MFIM
nr displays networking resources table (IP
addresses and subnet addresses)
ns xx (xx = code) xxx.xxx.xxx.xxx
Codes:
hi = setting MFIM address
hm = setting MFIM subnet mask value
hg = setting gateway IP address
cs = setting start address for clients
ce = setting end address for clients
cm = setting network mask for clients
changes network settings
p xxx.xxx.xxx.xxx pings (test) to determine if IP line to MFIM (or
other specified device) is operational. Use a
space after "p" in the command.
ren c: xxxx (old name) xxxx (new name) *renames file
reset 0 resets system
reset all reassigns all IP addresses
reset ip used when replacing MFIM, if user wants to keep
addresses of all system devices
reset mac resets MAC address
reset xxx (xxx = slot number) resets a slot
ta all xx (xx = time code)
Time Codes
:
lh = last hour
tp = today peak
tt = today total
yp = yesterday peak
yt = yesterday total
prints all traffic report
ta atd xx (xx = time code)
Time Codes
:
lh = last hour
tp = today peak
tt = today total
yp = yesterday peak
yt = yesterday total
prints attendant traffic
ta callhour prints call hourly report
ta callsum prints call summary report
ta cohour (cogrp#) prints CO traffic hourly report
ta cosum xx (xx = time code)
Time Codes
:
lh = last hour
tp = today peak
tt = today total
yp = yesterday peak
yt = yesterday total
prints CO traffic summary report
Diagnostic/Maintenance Commands Descriptions