Specifications

4-6 Monitor
Chapter 4 - Maintenance and Troubleshooting
vlog hh (hh = bit) sets trace options for H.323 protocol stack log. Bit values are:
07 - LOG_DEBUG 03 - LOG_ERR
06 - LOG_INFO 02 - LOG_CRIT
05 - LOG_NOTICE 01 - LOG_ALERT
04 - LOG_WARNING 00 - LOG_EMERG
d xxx (xxx = address 1) xxx
(xxx = address 2)
dumps memory between the two addresses, which are in hex-
decimal form. If only a single address is entered, the one page
memory area (composed of 320 bytes) will be dumped.
m xxx (xxx = address) modifies the value of specified memory area
dc displays registered device configurations
c xxx (xxx = CO line #) displays CO line status
c xxx [d] (xxx = CO line #) displays CO line structure format data
s xxx (xxx = Sta #) displays station status
s xxx [d] (xxx = Sta #) displays station structure format data
x exits the Monitor Commands area
? displays the monitor command list and descriptions
You can also set virtual dip-switch via IP Keyset using PGM 452, Btns 1-7.
Btn 1 = Call Trace
Btn 2 = VOIP Trace
Btn 3 = http Trace
Btn 4 = SMDI/in-band for voice mail Trace
Btn 5 = Device Polling. MFIM checks if devices are still connected. By default, this is turned on.
Btn 6 = Multicast Trace
Btn 7 = Multicast LED
Monitor Commands Descriptions