Specifications

Monitor 4-5
Chapter 4 - Maintenance and Troubleshooting
Monitor
Description
DescriptionDescription
Description
Monitor commands provide information on boards, devices, CO line status, station status,
memory information, etc.
Monitor Commands
After accessing the
Telenium
IP
system with HyperTerminal, type the monitor password
(jennie) and press [Enter]. A "mon >" prompt appears. Monitor commands are used by
typing in the desired command after the "mon >" prompt and then pressing [Enter].
The following are monitor commands and their descriptions.
Monitor Commands Descriptions
t b xx (xx = board slot #) sets board trace
t d deletes all current trace commands & reverts to idle condition
t s call sets (turns on) virtual dip-switch for call trace
t s voip sets (turns on) virtual dip-switch for VOIP Gateway trace
t s http sets (turns on) virtual dip-switch for Web-Server trace
t s poll sets (turns on) virtual dip-switch for device polling process
t s smdi sets (turns on) virtual dip-switch for SMDI trace
t s callid sets (turns on) virtual dip-switch for Multicast ID trace
t s all sets (turns on) virtual dip-switch for all traces
t r call resets (turns off) virtual dip-switch for call trace
t r voip resets (turns off) virtual dip-switch for VOIP Gateway trace
t r http resets (turns off) virtual dip-switch for Web-Server trace
t r poll resets (turns off) virtual dip-switch for device polling process
t r smdi resets (turns off) virtual dip-switch for SMDI trace
t r callid resets (turns off) virtual dip-switch for Multicast ID trace
t r all resets (turns off) virtual dip-switch for all traces
t c s xxx (xxx = Sta #) sets device command trace for a station (Refer to Table 4-1,
“Command Event Trace Explanation,” on page 4-7)
t e s xxx (xxx = Sta #) sets event trace for a station
t a s xxx (xxx = Sta #) sets trace mode, full or brief (toggle)
t p s xxx (xxx = Sta #) displays trace option configurations
t c c xxx (xxx = CO line #) sets device command trace for a CO line (Refer to Table 4-1,
“Command Event Trace Explanation,” on page 4-7)
t e c xxx (xxx = CO line #) sets event trace for a CO line
t a c xxx (xxx = CO line #) sets trace mode, full or brief (toggle)
t p c xxx (xxx = CO line #) displays trace option configurations