Specifications

Install additional SHUB8 Modules (optional) 3-37
Chapter 3 - Installation
Install additional SHUB8 Modules (optional)
14. Additional SHUB8 modules can be installed in any available slot besides the MFIM
slot. For clarity when connecting devices, it is recommended that you place
additional SHUB8s next to the first SHUB8.
15. The second SHUB8 can be connected by plugging a patch cord from the uplink
port on the first SHUB8 into a numbered port on the second SHUB8. Leave the dip
switch for the numbered port in the "off" position. Refer to Figure 3-29: SHUB8
Connection Diagram on page 3-38.
16. Connect any subsequent SHUB8s the same way; by patching port 1 into the uplink
port of the previous SHUB8.
17. Connect power cords to the SHUB8 modules.
Install IP Keysets
18. Determine which keyset will be the attendant station, and connect it to the
network with the supplied patch cord.
19. At the Telenium chassis, plug the RJ-45 connector corresponding to the keyset’s
location into a port on a SHUB8.
20. Flip the dip switch corresponding to the selected SHUB8 port to the "on" position.
21. Wait 10 seconds for the station to be discovered and assigned station ID 100.
22. Repeat the above steps for each additional keyset.
Gateway Port Discovery Process
The discovery process for gateways works the same way as the process for keysets;
when a gateway is connected and powered on, the MFIM discovers it and assigns it a port
ID.
When connecting a gateway with the optional upgrade module (SLTM2 with SLTU2), it is
possible for the second pair of ports to be discovered by the MFIM before the first pair. If
this happens, the assigned numbers may not be in the expected order. These port
assignments can be changed in the KSU’s software if desired. This also applies to other
gateway module options, such as DIDM2 with DIDU2 upgrade.
Keysets should be installed one at a time because station numbers are
automatically assigned by the order in which they are discovered by the
MFIM.
When moving IP phones from one port to another, it is not necessary to flip
the dip switches on the SHUB8 on/off to disconnect or reconnect. Simply
ensure that no devices except keysets are plugged into ports with dip switches
in the "on" position.