Specifications
IP Keyset Installation 3-35
Chapter 3 - Installation
Wall Mount
The IP Keysets can be mounted on the wall using the IP Wall Mount Kit. The Wall Mount
Kit is installed as follows:
1. Using the Wall Bracket, mark and drill two 7 mm holes for the plastic wall anchors
provided.
2. Insert the two anchors into the holes and insert and tighten the two screws
leaving about 6 mm (ΒΌ inch) exposed.
3. Slide the Wall Mount bracket over the screws and tighten securely.
4. Connect a short Cat 5 cable, to the IP Keyset and the wall jack.
5. Mount the IP Keyset onto the Wall Mount bracket.
6. Insert the Wall Mount handset hook to prevent the handset from slipping when
wall mounted.
Figure 3-27: Keyset Wall Mount Installation
The DSS installation with IP-24D / 24DH is shown in Figure 3-28.
Figure 3-28: DSS Installation