Specifications

SHUB8 Installation 3-27
Chapter 3 - Installation
The connector pin assignments for the RJ-45 type jack on BRIM2 are as shown:
 Wire each RJ-45 to a BRI line at the ISDN termination point/MDF.
 Tag or number wiring for maintenance.
Figure 3-19: BRIM2 BRI Line Connector Configuration
AC/DC Adapter
Assure the AC/DC Adapter is plugged into a live AC outlet and the Module Power jack.
SHUB8 Installation
The SHUB8 may be installed in any slot of the Main Cabinet, except for slot ten, or may
be installed anywhere in the Desk Mount Holder. The SHUB8 is employed to connect IP
Keysets, standard VoIP phones and other IP Modules to the
Telenium
IP
Zone. The SHUB8
has eight switched 10/100 Base-T Ethernet ports and an "UPLINK" port for a total of nine
switched ports. The eight switched ports can provide DC power of 48 Volts over the LAN
to remotely power the IP Keysets and DSS consoles based on the dip switch settings.
Figure 3-20: SHUB8 Switch Close-up