Specifications

MFIM Installation 3-21
Chapter 3 - Installation
Wiring Connectors
Before wiring any of the Modules, first connect the "GND" screw on the back of the
Module to a known earth ground. Refer to
“Module Grounding” on page 3-14.
On the front of the MFIM are the "LAN 1" and "LAN 2" RJ-45 connectors. These
connectors should be wired to the appropriate LAN points as discussed in
“LAN
Connections” on page 3-15
and “LAN Wiring Structures” on page 3-16.
V Wire "LAN 1" to a 10/100 Base-T switch. A SHUB8 can be used to form the
Telenium
IP
Zone.
V Wire "LAN 2" to a 10/100 Base-T switch. A SHUB8 can be used to form the
Telenium
IP
Zone.
V Tag or number wiring for maintenance.
On the rear are eight RJ-11 connectors terminated for miscellaneous functions, which
should be wired as in
Figure 3-16. When using a Main Cabinet, refer to “Main Cabinet Wiring”
on page 3-29
for wiring instructions.
V Wire Miscellaneous function connectors as depicted in the sketches of Figure 3-16
below.
V Tag or number wiring for maintenance.
Figure 3-16: MFIM Miscellaneous Function Connections
AC/DC Adapter
Assure the AC/DC Adapter is plugged into a live AC outlet and the Module Power jack.
CAUTION: Before connecting the LAN from SHUB8, the appropriate switch
for DTE power must be in the "OFF" position.