Manualshelf

Specifications

ManualsBrandsVodavi ManualsConsumer electronicsTelenium IP
51525354555657585960
3-20 MFIM Installation
Chapter 3 - Installation
MFIM Installation
The MFIM Module must be installed only in slot ten of the Main Cabinet. This slot is
dedicated to the MFIM. When Desk mounting Modules, the MFIM may be inserted
anywhere in the Desk Mount Holder.
LEDs
In addition to the Power and LAN LEDs, the MFIM has ten LEDs for status and diagnostic
information as described in the following table.
MODE Switch & Settings
The MFIM has a four-position dip switch identified as the "MODE" switch. The function of
each switch position is given in the following table.
To enter data in the system’s database, the Write Protect switch must be in the OFF
position. In the ON position, the database cannot be modified. Thus, placing the switch in
the ON position eliminates the potential for remote database modification. If remote data
entry is not desired, after all installation and database entries are complete, place the
switch in the ON position.
The system database is initialized based on switch position 4. In the ON position the
system will load default values in the system database and conduct a general Module
registration when power is applied to the MFIM. Note that if the system loses power for
any reason with the switch in the ON position, the database will be initialized. Place the
switch in the OFF position to maintain the database in the case of power loss or reset. For
a description of the initialization process refer to the
Telenium
IP
System Programming
Manual.
LED DESIGNATION LED STATUS FUNCTION - ON
S1 Serial/TCP debug active
S2 Call Processing active
S3 Active data communication with Modules and IP keysets
S4 LCD control active
S5 Clock alive (flashing)
BGM BGM or internal MOH is active
PAGE Ext. Page 1 or Ext. Page 2 is active
RECORD VSF Record active
PLAY VSF Play-back active
VMU Voice Storage Memory Unit installed
Switch Function OFF ON
1 Database write protect Unprotect Protect
2 Service Switch Service Normal
3 Registration Authorization Disallow Allow
4 Initialization Initialize on reset Read stored DB on reset