Specifications

3-10 Module Wall Mount Holder Kit
Chapter 3 - Installation
Module Wall Mount Holder Kit
The Module Wall Mount Holder will house a single Module.
To install:
1. Place the Wall Mount Holder in position and mark two holes over a wall stud. If a
wall stud is not found, a wall fastener such as a toggle bolt must be used.
2. Drill pilot holes for the 7 mm x 38 mm (#10 x 1½ inch) or larger screws, if a stud
location cannot be found, wall fasteners such as toggle bolts should be used.
3. Insert the two screws into the pilot holes, leaving about 6 mm (¼ inch) exposed.
4. Place (hang) the Wall Mount Holder on the screws and tighten securely.
5. Slide the Module into the Wall Mount Holder until it locks.
6. Connect all wiring to the Module as appropriate.
Figure 3-7: Module Wall Mount Holder Kit
Device Installation Guidelines
Device Installation GuidelinesDevice Installation Guidelines
Device Installation Guidelines
Station numbers are assigned consecutively based on the order of connection to the
system. Since the first IP Keyset is assigned as the Attendant (station number 100), it is
recommended that the IP Keyset for station 100 be connected to the system prior to
installing any SLT gateway Module.