Specifications

3-6 Main Cabinet Installation
Chapter 3 - Installation
Follow the steps below for installation.
1. Remove the Hinge pin from the Hinge plates.
2. Mount the separated Hinge plates, one to the Wall Mount bracket and one to the
Main Cabinet using the M6 x 8 mm machine screws, nuts and washers (four for
each Hinge plate) provided.
3. Use the Wall Mount kit to mark the location of four mounting holes for the Wall
Mount kit.
4. Drill four pilot holes for 7 mm x 38 mm (#10x1.5 inch) or larger screws.
5. Insert the screws in all four pilot holes and tighten, leaving about 12 mm (1/2
inch) exposed.
6. Place the Wall Mount kit on the four screws and tighten the screws securely.
7. Mount the Main Cabinet to the Wall Mount kit by aligning the Hinge plates and
inserting the Hinge pin.
Figure 3-3: Cabinet Wall Mount Kit Installation