User guide

56 Keyset Mode
STSe Station User Guide August 2005
Keyset Mode
This feature allows you to determine the mode and baud rate of the
optional CTI Module connected to your phone. This setting is
stored in back-up memory in the case of a power outage or system
reset. When telephone is set to AT command mode, these AT
commands are supported.
Mode Description
Inactive No CTI information is sent/received by the telephone.
ATD Modem Dialing Command -- The telephone will recognize
the ATD and accept digits after the command.
ATH or
ATHX
(X= 0 or 1)
Modem On-Hook/Off-Hook Command -- ATH or ATH0 will
force the telephone to go to the on-hook state from its
current state. ATH1 will force the telephone to go to the off-
hook state from it’s current state.
CKTU Command used with Wanderer (a cordless key telephone
unit). The baud rate is not used in this mode; no change is
necessary.
PC Phone CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI Service Provider Interface -- Command used with TAPI
applications such as Discovery Link