Specifications

Issue 2 - May, 2004 Talkpath - Digital Voice Processing System Technical Manual
2-8 Installation
Optional Station Programming
7 Program CO Line Ringing Assignments to ring CO lines directly to voicemail, if necessary.
a Press [Flash 40].
b Enter the CO line range (CO line numbers are 3 digits in length).
cPress [HOLD].
d Press [Button 10]. The following displays:
e Dial [4407].
f Press [HOLD] to save.
8 Plug the voicemail ports into the digital voicemail.
9 Apply power to the voicemail unit.
10 Program the voicemail system to match the phone system type. Refer to the Voicemail
Administration manual for instructions.
11 Configure Subscriber, Menu, Class of Service, Time Control, and Voice Line settings
through laptop/PC administration. Refer to Section 5.
Optional Station Programming
Perform the following steps to program the stations:
1 Enable Call Forwarding on the station if using the voicemail Blind Transfer option.
a Lift handset or press [ON/OFF].
bPress the FWD button
c [7] = no answer calls
d [8] = busy calls
e [9] = busy and no answer calls
f Dial [440]. A confirmation tone is heard.
g Replace the handset or press [ON/OFF].
NOTES
Voicemail ports must be plugged into the digital voicemail
system to allow boot up.
RING ASSIGNMENTS
ENTER DDDR