Specifications

Installation 2-3
Hardware Installation
Talkpath - Digital Voice Processing System Technical Manual Issue 2 - May, 2004
The figure below shows the Digital Voice Processing System unit mounted on the wall.
Figure 2-2. Wall Mounted Digital Voice Processing System
Connecting Phone Lines
Connect the phone lines by plugging each line into an RJ-11 jack, the same as with a digital
station. This can be done whether the Talkpath Voice Processing System unit is on or off.
Connect all voicemail ports to digital ports on the phone systems. Voicemail port 1 must be
connected to the system for the system to operate. The last active voicemail port must be
connected so Message Waiting Indicators (MWI) and notifications are available. Connect the
digital phone lines to voicemail before powering on the voicemail unit.
The unit has four or eight RJ-11 line connectors on the back, but only the number of ports ordered
are active.
NOTES
Do not connect analog phone lines to the Digital voicemail because
equipment failure can occur.
Ports can be installed after the system is booted, but two calls
must be placed to that port before it will answer. It is suggested
to reboot the system to activate each additional port.