Specifications

Technical / Troubleshooting 7-21
Debug Mode
Talkpath - Digital Voice Processing System Technical Manual Issue 2 - May, 2004
Debug Mode
To have more logging information, add a registry parameter ModuleDebug. ModuleDebug
accepts several parameters as shown in Table 7-1. Module Debug Parameters.
For example, to see if menus and time controls are configured correctly, enter the Admin module
and insert the ModuleDebug name with a value of
TcMn.
To see if your menus and time controls are configured properly, do the following (via Laptop/PC
Admin):
1 Access the Laptop/PC Admin and select Setup, Advanced, Registry.
2 Find the ModuleDebug parameter. If it is there, double-click and modify the value.
Otherwise, insert the value name.
3Enter
TcMn.
4 Click OK.
Via ECom:
1Access ECom.
2 Press Send next to +DIE0.
3 At the
C:\HELLO> prompt, type REGADD ModuleDebug=MnTc and press [Enter].
To see the active call come through the voicemail unit, run the voicemail engine in debug mode
as follows:
1 Access the voicemail unit via ECom.
2 Click Send next to +DIE 0. At the
C\HELLO> prompt, type VMDEBUG. This puts the system
in debug mode and shows calls in the system. When XSIAM shuts down for a brief time, the
system is ready to receive calls.
3 To exit debug mode, press [3]. The engine shuts down and the
C\HELLO> prompt
displays.
4 To put the system in stealth mode, type
VMRUN at the DOS prompt.
NOTES
Remove debugging parameters from the registry to conserve
hard drive space and to maintain system speed.