Specifications

Issue 2 - May, 2004 Talkpath - Digital Voice Processing System Technical Manual

1-2 Introduction

System Unit

The following graphic shows the front and back panels of the Talkpath Voice Processing System.

❐ When lit, the red LEDs on the front panel indicate system status, port configuration, and

boot sequence.

Figure 1-1. Voice Processing System - Front & Back Panels

❐ The AC adapter supplied with the system connects to AC power. The RS-232 serial port is

available to connect to a PC, laptop or a customer provided 9600 bps or better modem.

❐ Four or eight line connectors connect the Talkpath Voice Processing System to a

supported phone system. On 2-port systems, there are four jacks: 1 and 2 are active, jacks

3 and 4 are inactive. On 6-port systems: jacks 1-6 are active, jacks 7 and 8 are inactive.

❐ The battery compartment holds eight AA alkaline batteries that retain the system clock in

case of a power failure (batteries are not included).

NOTES

If the LEDs do not match the port count, refer to Section 7

Technical / Troubleshooting

NOTES

For the unit to operate, port 1 MUST be connected.

Plugging a single line port into the Digital voicemail

system can damage the equipment

Battery

Power

Adapter Plug

RS-232

Serial Port

Port

Jacks

LED Indicators

- FRONT PANEL -

- BACK PANEL -

Access Panel