Specifications

CO Line DTMF Sending 2-71
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Programming Steps
1. Press the CO LINE ATTRIBUTES flexible button (FLASH 85, Button #2).
2. To print data for:
 ALL CO Lines, press the HOLD button.
 A specified CO Line Range, enter 6 digits (3 digits for the first line and 3 digits for the
last line in the range):
 One CO Line, enter that line twice: [001001]
3. Then press the HOLD button. The following message displays and the CO Line data prints:
When the system finishes sending the requested information to the printer, a
confirmation tone sounds.
CO Line DTMF Sending
Each CO interface circuit for outside lines can be individually programmed to send DTMF
(tone) or dial pulse signals.
DTMF / Dial Pulse Programming
Description
Each individual outside line can be programmed to be DTMF (tone) or dial pulse.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
PRINT CO LINES
PRESS HOLD
PRINTING CO LINES
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO line range, all CO lines are selected.