Specifications

CO Line - Access 2-67
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
EXAMPLE 1 -- If [01003] is dialed and the HOLD button is pressed, the CO line number of
the first entry on the display changes to [003]. Since [003] was shown as the third entry on
the display, that entry is blank (###).
EXAMPLE 2 -- If Button #3 (CO Ports 9-12) is pressed, the following display appears:
EXAMPLE 3 -- If [03012] is dialed, the CO line number of the third entry on the display
changes to [012]. Since [012] was shown as the fourth entry, that entry is blank (###).
CO Line - Access
Description
Through programming, telephones are allowed or denied access to particular outside lines or
line groups. Refer to “Line Group Access - Station” on page 2-73, “Flexible Button Function
Assignment” on page 2-163, and “CO Line Group Programming” on page 2-74.
Operation
To access an outside line:
1. Press idle CO line button, POOL button,
-or-
Dial CO line group access code or LCR code: 9, 801-823 or 88+LLL
(LLL = CO Line number).
2. Dial desired number for outside call and lift handset to converse (or use speakerphone).
 SINGLE LINE TELEPHONE
To access an outside line:
1. Lift the handset, and dial access code: 9, 801-823, or 88+LLL (LLL = CO line number).
2. Then dial telephone number.
Conditions
» Access to trunk group must be programmed by installer/administrator.
» The CO line must be idle.
CO 003 002 ### 004 005
CO 009 010 011 012
CO 009 010 012 ###
When all the CO Line numbers desired have been programmed, a system reset
is required to update the data. This is done so that the programming of CO
Lines can be done while the system is in use.