Specifications

Uniform Call Distribution 4-11
Uniform Call Distribution
STARPLUS STSe - Programming & Operations Manual August 2005
To program a Table for Digital Voice Mail:
1. Press the TABLE X flexible button (1-16).
2. Dial [4] for the Voice Mail function.
3. Dial the desired Voice Mail Group number, using a 4-digit format, e.g., for Voice Mail
Group 440, enter 0440.
4. Dial (0-9).
0 = No DTMF Detection, No Messages Played (Default).
1 = DTMF Detection, No Message.
2 = No DTMF, Place In Queue Message.
3 = DTMF Detection, Place In Queue Message.
4 = No DTMF, Hold Time Message.
5 = DTMF Detection, Hold Time Message.
6 = No DTMF, Both Messages.
7 = DTMF Detection, Both Messages.
8 = Not used at this time.
9 = Not used at this time.
5. Dial a three-digit menu number [000-999].
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
To clear entries:
1. Press the [#] button.
2. Then press HOLD.
Ring Timer
Description
The UCD Ring Timer determines how long a call rings into a busy UCD group before being
presented to the first recorded announcement. The UCD Ring Timer setting is variable from
000–300 seconds.
Programming Steps
1. Press the RING TIMER flexible button (FLASH 61, Button #1). The following displays:
2. Enter a valid number on the dial pad which corresponds to 000-300 seconds.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … UCD Ring Timer is set for 60 seconds.
To program a Table for Flash-based Voice Mail, refer to “Recorded Announcement
Tables” on page C-5.
A RAN Table must be specified in UCD programming. If a RAN Table is NOT specified,
incoming CO callers are not answered but continue to receive ringback.
RING 000-300
060