Specifications

Tenant Groups 2-315
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
XXX-XXX = CO Line Range
4. Press the TENANT GROUP flexible button (Button #17).
5. Enter a valid number 0-9 to associate the CO lines to a Tenant Group 0-9 respectively.
6. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … All lines are set for Tenant Group 0.
Incoming Ring Assignments
Description
Incoming DID or DNIS call routing for Tenent Groups is programmed in this feature.
Programming Steps
1. Press FLASH and dial [43]. The Button #1 LED is illuminated and the following message
displays:
000 = Route Number (000-251)
DDDD = 3- or 4-Digit Ringing Destination Number
R = Ringing Type
2. Either press Button #20 and enter a valid number for the route to be programmed or use
Buttons #18/#19 to scroll up or down to select the desired route, then press HOLD.
3. Press the TENENT GROUP flexible button (Button #10). The following message displays:
4. Enter valid number on dial pad (0-9) to specify the desired group.
5. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Tenent Group 0.
XXX - XXX PAGE A
ENTER BUTTON NUMBER
TENANT GROUP 0-9
00
ROUTE 000 DDDDRR
TENENT GROUP 0-9
0