Specifications

911 Feature 2-5
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
911 Feature
Description
The 911 Feature allows stations in the system to dial 911 without using an access code. 911
calls are placed on 911 marked lines. If all lines are busy, an existing call is dropped and the
911 call is placed.
When this feature is enabled, Trunk Group/LCR Access Code 9 is not available.
Related Information
Programming Steps
To enable/disable the 911 feature:
1. Press the 911 FEATURE flexible button (FLASH 06, Button #13). The following displays:
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
[0] = Disabled
[1] = Enabled
DEFAULT … Disabled
To designate the line(s) for 911 use:
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
XXX-XXX = CO Line Range
Quick Reference

Flash 12 To insert [9] for Centrex 911 calls (refer to “PBX Dialing Codes”
on page 2-60).
911 FEATURE 0-1
DISABLED
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
ENTER BUTTON NUMBER