Specifications

ISDN Programming - Page A 2-197
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
ISDN Programming - Page A
Description
This section describes the procedures and steps necessary to program ISDN attributes. When
entering the ISDN attributes portion of the database, the programmer may decide to enter
information for a range of slots or one specific slot. Range programming lets the programmer
change a specific parameter or a few parameters for an entire range of slots, leaving intact
the remaining data fields that do not require change. Those data fields continue to operate
with the previously programmed data. By default, Page A is shown.
Programming Steps
1. Press FLASH and dial [45]. The following message displays:
2. Enter a valid number for the range of slots being programmed. If only one slot is being
programmed, enter that number twice (02 02 = Slot 2).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that slot or group of slots:
YY = Slot (0-13)
Primary Rate Interface (PRI) CO Type
Description
Changes to PRI CO Type area are not possible at this time (setting = NI2).
Programming Steps
1. Press PRI CO TYPE flexible button (FLASH 45, Page A, Button #2).
2. To view a CO type setting, enter a valid number (1-4).
1 = NI2
2 = PPNI2 (point-to-point NI2)
3 = Future feature (5 ESS Custom)
4 = Future feature (Nortel)
DEFAULT … NI2 is the PRI CO type.
ISDN ATTRIBUTES
SELECT A SLOT RANGE
YY - YY PAGE A
ENTER BUTTON NUMBER
PRI CO TYPE 1-4
NI2