Specifications
ISDN 2-195
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
When using DNIS or ANI signaling (FLASH 40, Page B, Button #1), if the DID number
and the name in the DID Translation Table (set in FLASH 44) exceeds nine digits
(including the space between them), the name in the DID Translation Table will be
truncated to accommodate 15 digits for the calling party name display, e.g., GEORGE
is truncated to GEORG in the upper two examples of Figure 2-15.
Outbound DID Number on PRI
When the STSe sends caller ID information through the PRI to a central office, it is able to send
seven to ten digits to identify the exact station number to an outside caller who is equipped
with caller ID. Use of this feature allows the specific station number to be displayed instead of
the main directory number of the PRI line.
This feature is implemented on a per station basis.
Use Flash 50 programming when you want to modify a range of stations’ attributes using
fixed station numbers.
Use Flash 51 programming to modify a single station’s attributes using a flexible station
number.
Programming Steps
1. Press FLASH and dial [50] or dial [51]. Flexible button #24 (New Range) is lit and one of
the following messages displays:
2. Enter the range of fixed station numbers (100-149) to be programmed. If only one station
is being programmed, enter that number twice, e.g., [100 100].
-or-
Enter a valid flexible number (100-8999) to be programmed.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 is lit. The display updates to reflect current programming for Page A:
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
STATION ATTRIBUTES
SELECT A STATION RANGE
ENTER STATION NUMBER
If HOLD is pressed without entering a station range, All stations are selected.
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE A
ENTER BUTTON NUMBER
SXXX PAGE A
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number