Specifications

Headset Mode 2-175
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
7. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Option 1, the 2.5 mm jack, is the default setting.
Operation
The user connects the modular headset to either the handset jack on the telephone (leaving
the handset in place) or the 2.5 mm jack located on the left side of the keyset. The ON/OFF
button on the Digital Telephone is used to initiate and end calls while using the headset.
To activate Headset Mode:
Dial [634] on the dial pad,
-or-
Press preprogrammed HEADSET MODE button.
-or-
Use the Soft Key’s HEADSET option when in an idle condition.
To deactivate Headset Mode:
Dial [634] on the dial pad,
-or-
Use the Soft Key’s HEADSET option.
-or-
Press the preprogrammed HEADSET MODE button.
LED extinguishes.
 SINGLE LINE TELEPHONE
Not applicable
Conditions
» The Headset Mode flexible feature code 634 can be programmed onto a flexible button.
The button acts as a toggle (i.e., the first depression turns Headset Mode on, the second
depression turns Headset Mode off.
» Transmission and reception quality when using the headset is dependent upon the
headset used.
» Intercom calls to a station in Headset Mode will always be presented to the station in the
Tone Mode.
» If the 2.5 mm jack is used for the headset connection, a user may alternate between the
handset and the headset during a conversation by either lifting the handset or by
pressing [ON/OFF] and then replacing the handset to return to headset operation.
» Page announcements will be presented to the keyset speaker when the station is idle.
While Headset mode is active, the ON/OFF button activates the headset and
disables speakerphone and intercom call announce operation at your station.
To install the headset, see the Installation Manual.
Station must be programmed for headset operation in database programming
before the flexible button can be programmed.