Specifications

2-174 Headset Mode
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Programming Steps
1. Press FLASH and dial [50] or dial [51]. Flexible button #24 (New Range) is lit and one of
the following messages displays:
2. Enter the range of fixed station numbers (100-149) to be programmed. If only one station
is being programmed, enter that number twice, e.g., [100 100].
-or-
Enter a valid flexible number (100-8999) to be programmed.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 is lit. The display updates to reflect current programming for Page A:
4. Press button #20. The display updates to reflect current programming for Page B.
5. Press the DISPLAY BUTTONS flexible button (Button #18) to display programming
assignments. The following message displays:
6. Dial a valid option number (0 or 1) to identify the location where you plug the headset
into the STSe keyset.
0 = plugged into the jack normally used for the handset
1 = plugged into the 2.5 mm jack located on the left side of the keyset
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
STATION ATTRIBUTES
SELECT A STATION RANGE
ENTER STATION NUMBER
If HOLD is pressed without entering a station range, all stations are selected.
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE A
ENTER BUTTON NUMBER
SXXX PAGE A
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE B
ENTER BUTTON NUMBER
SXXX PAGE B
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number
HEADSET MODE 0-1
2.5 MM JACK