Specifications

2-160 Fax Detect
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Fax Detect
Description
This feature allows CO lines to be designated as fax detect line types. Upon a marked CO line
receiving a call, the CO line will be transferred to the fax detect circuit to determine if the call
is a fax call. If it is, the call will be sent to a pre-programmed destination, if it is not a fax call,
the call will ring to destinations in the ring assignment table.
Programming
Fax Detect enable/disable on a per CO line basis:
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible Button #19 (Page A) is lit.
4. Press the Page B flexible button (Button #20). The following message displays:
XXX-XXX = CO Line Range
5. Press the FAX DETECT flexible button (Button #18). The following message displays:
6. Enter a 0 or 1 that corresponds with the following entries:
[0] = Disabled
[1] = Enabled
7. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Fax Detect is disabled.
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE B
ENTER BUTTON NUMBER
FAX DETECT 0-1
DISABLED