Specifications

2-150 Do Not Disturb / Page Block
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Do Not Disturb Button Flash Rate
Description
The Do Not Disturb Button flash rate is the rate at which your Do Not Disturb button flashes
when you place your station in a Do Not Disturb mode. This flash rate can be programmed to
29 different options identified in the flash rate table. This enables the programmer to
customize the key system configuration to desired flash rates.
Programming Steps
1. Press the DND BTN flexible button (FLASH 07, Button #18). The following message
displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to Table 2-16 on page 2-163).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Do Not Disturb Button flash rate is set for Red Steady On (01).
Do Not Disturb - DSS/BLF Flash Rate
Description
This feature controls the rate at which your DSS/BLF buttons for other stations flash, to
indicate that they are in a Do Not Disturb mode. This flash rate can be programmed to 29
different options identified in the flash rate table. This enables the programmer to customize
the key system configuration to desired flash rates.
Programming Steps
1. Press the DND – DSS/BLF flexible button (FLASH 07, Button #6). The following message
displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to Table 2-16 on page 2-163).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Do Not Disturb DSS/BLF flash rate is set for a Red 60 ipm Double Wink Off (04).
DND BTN 00-28
RED STEADY ON
DND DSS / BLF 00-28
RED 60 IPM DBL WINK OFF