Specifications

2-114 Direct Inward Dialing
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
To change to a different DID Route Number:
1. Press either the UP Button (Button #18),
-or-
Press the DOWN Button (Button #19).
2. Enter a valid Route Number (000-251) to be associated with the DID Number.
This Route Number is the same Route Number in the ICLID Ringing Assignments Table
(FLASH 43) and determines the destination of the DID number associated with this
Route Number. The display shows the route number as it is entered.
3. Press the HOLD button to save the entry. A confirmation tone sounds.
DID Phone Number
Programming Steps
1. Press the PHONE NUMBER flexible button (Button #2) to program the DID Number.
2. Enter the DID Number to be associated with a valid Route Number (000–251). Up to
7 digits can be entered.
By default, only the last three digits are used for routing which is determined in Flash 43.
3. Use the BACK SPACE flexible button (Button #5) to erase the current number or to
correct for errors.
4. Press HOLD to save the entry. A confirmation tone sounds.
If the DID number is already in the DID Translation Table, the Route Number associated
with the DID number displays.
Name Assigned to DID Number
Programming Steps
1. Press the NAME flexible button (Button #3) to enter the desired name for the DID trunk.
Maximum length is 16 characters.
2. Press the HOLD button to update the database. A confirmation tone sounds.
3. Use the BACK SPACE flexible button (Button #5) to erase the current letter to correct for
errors.
By default, the DID Table is filled with numbers. If error tone is received when the HOLD button is
pressed, the DID Table is full and an entry needs to be deleted to make room for this new phone
number.