Specifications

2-86 CO Line Loop and Pool Buttons
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Use Flash 50 programming when you want to modify a range of stations’ attributes using
fixed station numbers.
Use Flash 51 programming to modify a single station’s attributes using a flexible station
number.
Programming Steps
1. Press FLASH and dial [50] or dial [51]. Flexible button #24 (New Range) is lit and one of
the following messages displays:
2. Enter the range of fixed station numbers (100-149) to be programmed. If only one station
is being programmed, enter that number twice, e.g., [100 100].
-or-
Enter a valid flexible number (100-8999) to be programmed.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 is lit. The display updates to reflect current programming for Page A:
4. Press the CO LOOP POOL flexible button (Button #17). The following message displays:
5. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disable
[1] = Enable
6. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … CO Loop Pool is disabled.
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
STATION ATTRIBUTES
SELECT A STATION RANGE
ENTER STATION NUMBER
If HOLD is pressed without entering a station range, all stations are selected.
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE A
ENTER BUTTON NUMBER
SXXX PAGE A
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number
CO LOOP POOL FLEX 0-1
DISABLED